Template Code has been loaded into the DVC7 and DVC10 module at the factory giving the programmer some examples of the type of programming syntax that is used. This program allows the output group PWM to be controlled by the analog input with the assistance of an I/O function curve, i.e. analog 1 will control output group1 coil1HS1 through Input/ Output Function curve valve_shaper_1.  Factory default gives a 1:1 ratio of input to output. This can be modified by using the Intella Program Loader Monitor (PLM). Start the PLM, select the DVC Master indicator to open the window that displays all the DVC I/O. Near the center of the screen contains a button labeled I/O functions. Selecting this button will display the I/O function curves. They are selectable by a yellow pull down menu located in the upper left hand corner. Using the output section, the user can adjust the 1:1 ratio, i.e. the user may determine, that having 20% input should deliver 40% PWM output. This is adjustable using this function. Remember to select ‘Send Changes’ to make the change active. These changes are automatically stored so they are present on the next power up.  Read more regarding the DVC7 application code or read more regarding the DVC10 application code.